Microwave and Radar Engineering 6th Sem/ECE/May 2019 Paper

Download Previous Year Diploma Paper of Microwave and Radar Engineering 6th Sem/ECE/May 2019 Paper

Microwave and Radar Engineering 6th Sem/ECE/May 2019 Diploma Question Paper

SECTION-A

Q1. a) Fill in the Blanks. 15×1=15

a. RADAR stands for ___________
b. ______ modes does not exist in a waveguide.
c. To couple a co-axial line to a parallel wire line, it is best to use a _______
d. The maximum unambiguous range in a system depends on ___________
e. A helical antenna produces _______ polarized waves.
f. VSWR stands for ________________
g. The line of sight communication range is limited due to ___________
h. The uplink frequency is different from downlink frequency to avoid _________
i. VSAT network is operated in _________ mode.
j. Antenna reciprocity is put to use in _________ systems.
k. __________ is a crossed field device.
l. In a hollow rectangular waveguide the phase velocity ____with increasing frequency.
m. PPI in a radar system stands for __________
n. The blind speed of MTI radar can be avoided by changing the _____rotation rate.
o. A coupling loop is placed at a point of__________ magnetic field intensity.

SECTION-B

Q2. Attempt any five questions. 5×6=30

i. What are the advantages of microwaves over low frequency signals?
ii. Differentiate between reflex klystron and multi cavity klystron.
iii. Define the various elements of a basic microwave communication link.
iv. Explain parabolic antenna in detail.
v. Explain microwave isolator in detail with diagram.
vi. Discuss in detail various transmission losses.
vii. Explain the basic concept of radar display PPI.

SECTION-C

Q3. Attempt any three questions. 3×10=30

a. Explain the various multiple access techniques.
b. What is MTI radar? Explain its working principle.
c. Explain construction and working of magnetron.
d. What is a directional coupler? Explain directivity and coupling factor. What is the main application of directional coupler?
e. Write a short note on the following. (any two)
i. Magic tee
ii. Radar range equation
iii. GUNN diode.

Microwave and Radar Engineering 6th Sem/ECE/May 2019 Diploma Question Solved Paper

SECTION-A

Q1. a) Fill in the Blanks. 15×1=15

a. RADAR stands for Radio Detection and Ranging .
b. TM01 or TM10 modes does not exist in a waveguide.
c. To couple a co-axial line to a parallel wire line, it is best to use a Balun .
d. The maximum unambiguous range in a system depends on Pulse Repetition Time (PRT) .
e. A helical antenna produces Circularly polarized waves.
f. VSWR stands for Voltage Standing Wave Ratio .
g. The line of sight communication range is limited due to Diffraction .
h. The uplink frequency is different from downlink frequency to avoid _________
i. VSAT network is operated in stand-alone mode.
j. Antenna reciprocity is put to use in RADAR systems.
k. Amplifier or Oscillator is a crossed field device.
l. In a hollow rectangular waveguide the phase velocity Decrease with increasing frequency.
m. PPI in a radar system stands for Plan Position Indicator .
n. The blind speed of MTI radar can be avoided by changing the _____rotation rate.
o. A coupling loop is placed at a point of__________ magnetic field intensity.